Kies het register waaraan je dit product wilt toevoegen:
Rogue Neutral Grips is rated
3.8 out of
Beoordeling 5 uit 5 door tortie van Great addition to your rig.This will work with the standard Rogue fat skinny bar as long as the fat bar is at the bottom. Granted it is not going to be parallel to the floor, its going to point up a bit, plus expect it to scruff up the powder coat of fat bar in the long run but is not a deal breaker for me.
Date published: 2019-11-25
Beoordeling 4 uit 5 door Jeff720 van Great product but...I do like these neutral grips a lot, but I thought it was worth mentioning that they will fit on the fat/skinny bar with the fat bar down but move the grips to the side a little bit, (not where you normally grip on the fat bar) because it does mark up the pull up bar some. Not so noticeable in my picture but I can feel where the damage was done when I grip my fat bar now.
Date published: 2017-12-26
Beoordeling 5 uit 5 door Burke van Excellent productI bought a squat stand and requested a dual Crossmember bar with the 1.25" diameter - these grips fit perfectly and adjust easily on the bar. Very happy with the product.
Date published: 2017-11-06
Beoordeling 3 uit 5 door fdfd van doesn't fit over fat part of fat/skinny S3 rackI was using the skinny pull up bar on my S3 rack, but these are too narrow to use unless I switch to the fat grip. This should be mentioned in the description.
I had imagined that they would be wide enough to fit the fat bar, and therefore could be used with both. Also they the ground clearance could have been increased by placing the handles a bit higher, but then head-ceiling clearance might be an issue unless you have a high ceiling or a squirrel head).
Have to choose between switching to a fat grip or returning them...
Date published: 2016-07-30
Beoordeling 2 uit 5 door Cliff van Poor design leads to an okay productAt average male height, 5'11", with the crossbar as high as possible on my standard RML-690, my feet are touching the ground when using the neutral grips, even with knees bent in excess of 45 degrees. This means that any exercise my hips have to bend significantly at the hips or knees unless I want my feet to hit the ground-- this is very annoying and easily avoidable by changing the design of the product. Would have preferred they moved the handles higher up, and don't see a reason why they didn't.