This Rogue loading pin works about as well as you could possibly expect a loading pin to work. Very strong and stable. Note you will need a fairly big carabiner (I use a 4" and it's kinda snug) to use with this and not struggle to get it on and off, as there is a good amount of metal on the upper side of the clip hole. This is not a flaw, as it should increase the strength of the attachment point and allow for a lot of weight to be loaded on this thing. I feel like the diameter of the pin is a perfect balance between ease of loading, and not having the weights wobble around while using it. Good design, good execution.

Like the knurled grips, and sturdiness. A little squeaky

Very sturdy and excellent quality, easy to use and resistant.

Solid piece of equipment. I use the loading pin for about 25% of my exercises at home. The 4 star is because of the sticker. Don't expect the sticker to stay on too long. The adhesive is not strong enough to adhere to the products finish. Similar to my Rogue Horizontal plate rack. It will eventually come off.

works great for a cable set up. but woulda been great if it was left as bare metal. its covered in black PAINT which yer beating the heck out of with plates and clamps!

Excellent part of my DIY pulley system. Weights slide on easy with very little wiggle. Great value!

It's a fine pin. My only complaint is that it's slightly undersized, so that a spring collar won't hold. This is only a problem when holding the pin horizontal, such as when doing plate pinches.

Very well made and solid pin. Inexpensive relative to the high quality. All welds are smooth and well finished.