Add to Registry
Please choose the registry you want to add this product to:
|Made In USA||Yes|
|Length||77.25" (with bench)|
|Width||80.25" (total width) / 43.5" (inside width)|
|Height||78" (highest point with uprights fully extended) / 17.5" (Bench Height)|
|Steel Notes||3x3" 7-Gauge Steel|
|Foot Print||77.25" x 80.25"|
The Combo Rack comes equipped with a lever-arm jack system and telescoping uprights to enable custom height adjustments without having to remove plates from the bar in advance. Because there are two separate pairs of J-cups (one set for Squat and one for Bench), the racked bar height is adjustable from a minimum height of 29.461" (from the floor) up to 68.405". Shorter athletes can also elect to use the higher bench J-cup positions for squats.
Bench J-Cup Range (from floor): 29.461" up to 57.461"
Squat J-Cup Range (from floor): 40.405" up to 68.405"
Each J-cup also includes an acetal roller where the bars rests to allow for easy adjustments left to right while the user is getting set up.
The uprights on the Rogue Combo Rack are manufactured from 3x3" 7-Gauge Steel with laser-cut numbering and an MG Black powdercoat finish. The telescoping tubes are made from stainless steel. A set of (4) stainless steel machined pins are used to set the uprights’ height, which can be adjusted using the 1" on-center holes. Athletes can set-up the uprights either straight-up or angled inward 5 degrees; the latter set-up enables larger athletes to put their hands on the outside of the J-cups when squatting.
The Combo Rack’s bench comes standard with a competition Fat Pad (50" L x 12.5" wide x 4.5" thick). The top of this durable pad sits 17.5” above the floor. The bench also includes two diamond tread spotter decks that are finished in a texture black powder coat to provide “grip” and a stable platform. Athletes can easily remove the bench to set up the rack for squats.
The steel spotter arms on the unit measure 19.5” in length x 3” wide, and include stainless steel telescoping tubes + a UHMW plastic covering to protect the bar should a lift be failed. The spotters are also easy to remove when you switch over to squats.
The Combo Rack is made in the USA and built to International Powerlifting Federation requirements for competition use. The inside width of the rack is 43.5", and the overall footprint (with the bench installed) is a space efficient 77.25" deep x 80.25" wide. The unit is also equipped with important protection/safety features, including rubberized feet for stability and UHMW plastic to help prevent contact damage to your equipment or flooring. All components of the rack (uprights, bench, spotter arms) include special tightening knobs to further improve the stability and rigidity of the rack.
The Rogue Shipping System allows you to track your order from the time you place it to the time it hits your door.